Pioneer AVIC-S1 User Manual page 70

User's manual AVIC-S1
- 68 -
Alignment of the map
Red point shows up (north): the map is therefore aligned so that
north is always at the top. Tap on the button to align the map in
accordance with the driving direction.
The northerly view corresponds to the map alignment on printed
maps, but is impractical for navigation purposes.
Red point is not pointing upwards: the map is aligned so that the
driving direction is always at the top. Tap on the button to align
the map to the north.
Alignment to the driving direction is recommended for the
navigation because the directions right and left on the map are
then shown exactly as they are in reality.
Note: North alignment is only possible when the map is being
displayed in 2D mode. In 3D mode, north alignment does not
make sense.
Back
The Back button is only visible if the zoom level bar is shown.
Tap on this button to hide the zoom level bar and maintain the
altered map scale.
Autozoom
The Autozoom button is only visible if the zoom level bar is
showing and the map scale has been changed.
Tap on this button so that the map scale is automatically
changed according to your speed: if you drive slowly, the map
scale becomes smaller, if you drive quickly, the map scale
becomes greater.
Show entire route
The button is only visible if a route has been calculated. Tap on
this button to view the entire route in the map.
Note: By tapping in the map you can quickly change the map
view to Search for destination. Refer to the next chapter for
more information ("Search for destination view" on page 69).
Map views