Assembly - NordicTrack Incline Trainer X11 User Manual

ASSEMBLY

• To watch an assembly
video, go to
http://productvideo.co/
assembly/nordictrack or
use your mobile phone
or smartphone to read
the QR code at the right.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance on
the exterior of the incline trainer. This is normal.
1. Make sure that the power cord is unplugged.
Identify the right Upright (77), which has a wire
tie in it. Hold the Upright near the right side of
the incline trainer.
See the inset drawing. Tie the wire tie in the
right Upright (77) around the end of the Upright
Wire (78). Then, pull the other end of the wire tie
until the Upright Wire is routed out of the top of
the Upright.
If there is an oily substance on the incline trainer,
wipe it off with a soft cloth and a mild, non-abra-
sive cleaner.
• Left parts are marked "L" or "Left" and right parts
are marked "R" or "Right."
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex keys
Phillips screwdriver
To avoid damaging parts, do not use power tools.
1
Wire
Tie
78
77
7
Wire
Tie
77
78