NordicTrack Gx 2.7 Bike Manual page 9

3. Remove and discard the shipping screws and
the shipping tube (not shown) on the front of the
Frame (50), if necessary.
Set a sturdy piece of packing material under the
front of the Frame (50).
Attach the Front Stabilizer (63) to the Frame (50)
with two M8 x 70mm Screws (46).
Remove the packing material from under the
front of the Frame (50).
4. Set the Seat Carriage (15) on the Seat Post (18)
and hold it in place.
Insert the Seat Knob (19) upward into the Seat
Post (18), and tighten the Seat Knob into the
Seat Bracket (14) inside the Seat Carriage (15).
5. Hold the Seat Post (18) near the Frame (50),
and position the Seat Post Bushing (21) so that
the lock tab is covering the oval hole in the Seat
Post.
Have a second person loosen the Seat Post
Knob (28) a few turns and pull it outward.
Insert the Seat Post (18) and the Seat Post
Bushing (21) into the Frame (50) until the lock
tab snaps into the indicated hole in the Frame.
Next, slide the Seat Post (18) upward or down-
ward to the desired position, and release the
Seat Post Knob (28) into an adjustment hole in
the Seat Post. Then, tighten the Seat Post Knob.
Move the Seat Post (18) upward or downward
slightly to make sure that the Seat Post Knob
(28) is engaged in an adjustment hole.
3
4
15
14
19
5
Adjustment
Lock Tab
Oval Hole
28
9
46
63
50
18
Holes
18
21
50
Hole