Pioneer DVH-P500UB Operation Manual page 78

Section
03 Available accessories
1 Use MULTI-CONTROL to select PEQ-2.
Refer to Introduction of DSP adjustments on
page 67.
# Adjusted PEQ-2 settings are memorized in
CUSTOM 1.
2 Push MULTI-CONTROL left or right to
select the desired item.
FRONT (speakers)—LOW (bands)—200 (cen-
ter frequency)—0 (equalizer level)—WIDE (Q
factor)
3 Push MULTI-CONTROL up or down to
select the speaker to be adjusted.
FRONT (front speakers)—CENTER (center
speaker)—REAR (rear speakers)
# You cannot select speakers whose size is set
at OFF. (Refer to Setting the speaker setting on
page 73.)
4 Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to select
the equalizer band to be adjusted.
LOW (low)—MID (mid)—HI (high)
5 Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to select
the center frequency of selected band.
40HZ—50HZ—63HZ—80HZ—100HZ—
125HZ—160HZ—200HZ—250HZ—315HZ—
400HZ—500HZ—630HZ—800HZ—1KHZ—
1.25KHZ—1.6KHZ—2KHZ—2.5KHZ—
3.15KHZ—4KHZ—5KHZ—6.3KHZ—8KHZ—
10KHZ—12.5KHZ
6 Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to ad-
just the equalizer level.
+6 to –6 is displayed as the level is increased
or decreased.
7 Push MULTI-CONTROL right and then
push MULTI-CONTROL up or down to select
the desired Q factor.
WIDE (wide)—NARROW (narrow)
78
En
# You can adjust parameters for each band of
the other speakers in the same way.
8 Press BAND to return to the ordinary
display.
Note
You can select a center frequency for each band.
You can change the center frequency in 1/3-oc-
tave steps, but you cannot select frequencies that
have intervals shorter than 1 octave among the
center frequencies of the three bands.