Adjusting Loudness; Using Subwoofer Output - Pioneer DVH-P500UB Operation Manual

Section
02 Operating this unit
Low: 40HZ—80HZ—100HZ—160HZ
Mid: 200HZ—500HZ—1KHZ—2KHZ
High: 3KHZ—8KHZ—10kHZ—12KHZ
4 Push MULTI-CONTROL up or down to
select the desired Q factor.
Each time MULTI-CONTROL is pushed up or
down, Q factor is selected in the following
order:
2W—1W—1N—2N

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select
LOUDNESS.
Refer to Introduction of audio adjustments on
page 42.
2 Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g., MID) appears in the dis-
play.
# To turn loudness off, press MULTI-CONTROL
again.
3 Push MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pushed left or
right, level is selected in the following order:
LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
Also, phase can be selected between normal
and reverse.
1 Use MULTI-CONTROL to select SUB W1.
Refer to Introduction of audio adjustments on
page 42.
44
En
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
NORMAL appears in the display. Subwoofer
output is now on.
# If the subwoofer output phase has been set to
the reverse, REV will be displayed.
# To turn subwoofer output off, press
MULTI-CONTROL again.
3 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and REV appears in the display. Push
MULTI-CONTROL right to select normal phase
and NORMAL appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
! When the subwoofer output is on, you can
select SUB W2.
1 Use MULTI-CONTROL to select SUB W2.
Refer to Introduction of audio adjustments on
page 42.
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50—63—80—100—125
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
+6 to –24 is displayed as the level is increased
or decreased.