Setting The Tv Signal; Correcting Distorted Sound; Resetting The Audio Functions - Pioneer DVH-P500UB Operation Manual

Operating this unit

Setting the TV signal

When this unit is connected to a TV tuner, you
need to adjust the TV signal suitable to your
country TV signal setting.
! About your country TV signal, consult with
your nearest Pioneer dealer.
1 Use MULTI-CONTROL to select
TV SIGNAL.
Refer to Adjusting initial settings on page 51.
2 Press MULTI-CONTROL to select an ap-
propriate TV signal.
PAL—SECAM

Correcting distorted sound

Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
1 Use MULTI-CONTROL to select D.ATT.
Refer to Adjusting initial settings on page 51.
2 Press MULTI-CONTROL to switch the di-
gital attenuator setting.
! HIGH – High quality sound
! LOW – Minimize distortion sound

Resetting the audio functions

Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
lume on page 18)
! Listening position setting (refer to Using
the position selector on page 68)
! Fader/balance setting (refer to Using bal-
ance adjustment on page 68)
! SLA (source level adjustment) setting (refer
to Adjusting source levels on page 70)
! Dynamic range control (refer to Using the
dynamic range control on page 70)
! Direct control setting (refer to Using the di-
rect control on page 70)
! Down-mix setting (refer to Using the down-
mix function on page 70)
1 Use MULTI-CONTROL to select
AUDIO RESET.
Refer to Adjusting initial settings on page 51.
2 Press MULTI-CONTROL to display OK.
# To cancel resetting the audio functions, press
BAND.
3 Push MULTI-CONTROL right to display
REALLY?.
# To cancel resetting the audio functions, press
BAND.
4 Press MULTI-CONTROL to reset audio
functions.
COMPLETE appears in the display.
Section
02
55
En