Attaching The Front Panel; Feature Demo Mode; Resetting The Microprocessor - Pioneer DEH-P7100BT Operation Manual

Section
01 Before You Start

Attaching the front panel

% Reattach the front panel by holding it
upright to the unit and clipping it securely
into the mounting hooks.

Feature demo mode

The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Press
DISP/SCRL during feature demo operation to
cancel the feature demo mode. Press
DISP/SCRL again to start. Remember that if
the feature demo continues operating when
the car engine is turned off, it may drain bat-
tery power.
Important
The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Removing the front panel
8
En
2 Press RESET with a pen tip or other
pointed instrument.
RESET button