Removing The Front Panel; Attaching The Front Panel; Resetting The Microprocessor - Pioneer DEH-P70BT Operation Manual

Section
01 Before You Start
! You can turn off the warning tone. See
Switching the warning tone on page 80.
Important
! Never use force or grip the display and the
buttons too tightly when removing or attach-
ing.
! Avoid subjecting the front panel to excessive
shocks.
! Keep the front panel out of direct sunlight and
high temperatures.

Removing the front panel

1 Press OPEN to open the front panel.
2 Grip the left side of the front panel and
pull it gently outward.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
3 Put the front panel into the protective
case provided for safe keeping.
10
En
All manuals and user guides at all-guides.com

Attaching the front panel

% Replace the front panel by holding it
upright to the unit and clipping it securely
into the mounting hooks.

Resetting the microprocessor

The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Remove the front panel.
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
3 Replace the front panel by clipping it
into place.
4 Turn the ignition to ACC or ON and
wait until the feature demo appears in the
display.
Resetting of the microprocessor is now com-
pleted.