Baby Monitor; Activate/Deactivate The Baby Unit; Send An Alert - Philips M888 Extended User Documentation

16 Baby monitor

Your phone supports the baby monitor function
which sends an alert if the sound level exceeds
the set limit.
Caution
•
Make sure that you do not leave the handset that has
the active monitor in the baby room.
•
Make sure the baby unit and the cord are always out of
reach of the baby.
•
Place the baby unit at least 1 meter/3 feet but not
more than 2 meters/6 feet away from the baby.
Activate/Deactivate the baby
unit
1
Select [Menu].
2
Press / to select
to confirm.
3
Select [Activate] , then press [OK] to
confirm.
» The baby unit is activated.
displayed.
Note
•
Make sure that the headset is not plugged into the
activated baby unit.
•
When the baby monitor mode is activated, the baby
unit does not ring on incoming calls.
32 EN
1-2m
, then press [OK]
is
Tip
•
If you have not set the parent unit, a notification
message is displayed. Then you are asked to select to
where you send the alert: external lines or another
handset. For information, see the next section.
•
To exit from the baby monitor menu, press [Off].

Send an alert

You can send an alert to other handsets within
the home or an external line. External line can
be a cell phone or another fixed line outside
the house.
Note
•
Make sure that any prefix digits and/or country code
are included when you send an alert.
Send to other handsets
1
Select [Menu].
2
Press / to select
to confirm.
3
Select [Send alert to] > [Connected line],
then press [OK] to confirm.
4
Select a handset, then press [OK] to
confirm.
Note
•
Make sure that the distance between the baby unit and
the parent unit is at least 1.5 meter away from each
other to prevent the howling effect.
Send to an external line
1
Select [Menu].
2
Press / to select
to confirm.
, then press [OK]
, then press [OK]