Miller Electric RGCR-1A Owner's Manual

OWNER'S MANUAL
Running Gear/Cylinder Rack (042 700), RGCR-1A (042 745),
And MW150RG (042 804)
WARNING
ELECTRIC SHOCK can kill.
Do not touch live electrical parts.
Turn Off welding power source and input
disconnect device.
Disconnect
deenergized supply BEFORE moving welding
power source.
CYLINDERS can explode if damaged.
Keep cylinders away from welding and other
electrical circuits.
Never touch cylinder with welding electrode.
Always secure cylinder to running gear, wall, or
other stationary support.
Crimp Items
1 & 3.
1
2
3
15
14
13
input power conductors
Remove and discard rear
handle of unit before install-
ing bottle retainer (4).
4
5
11
12
Remove
grooves (7) before installing re -
taining rings (10).
Figure 1-1. Installing Running Gear/Cylinder Rack
February 1994
Use above FORM number when ordering extra manuals.
FALLING EQUIPMENT can cause injury
and damage.
Use proper equipment to lift unit.
Use lifting forks long enough to extend out opposite
side of base.
from
Do not put any body part under unit while lifting.
7
7
8
9 10
paint from axle
FORM: OM-681A
Tools Needed:
3/8, 7/16, 9/16
miscwarn1.1 5/93
Item Part
No. No. Description (Qty)
1 602 389 S-Hook (1)
2 148 188 Chain (1)
3 602 384 Snap (1)
4 147 894 Bottle Retainer (1)
5 089 800 Nut, 1/4-20 (2)
6 089 799 Screw, 1/4-20 x 1/2 (2)
7 147 893 Axle (1)
8 090 693 Wheel, 8 in (2)
9 602 250 Washer, 3/4 flat (2)
10 121 614 Retaining Ring (2)
11 148 110 Pan (1)
12 602 154 Screw, 1/4-20 x 1/2
self-forming (4)
13 109 318 Caster (2)
14 602 211 Washer, 5/16 lock (2)
15 604 537 Nut, 5/16-18 (2)
Be sure to provide Model when ordering
replacement parts.
ST-149 470-C / ST-800 244
1994 MILLER Electric Mfg. Co.