Placing Jumper Links And Connecting Input Power - Miller Syncrowave 351 Owner's Manual

3-10. Placing Jumper Links And Connecting Input Power

200 VOLTS
L
220 VOLTS
L L
230 VOLTS
L
Connect GND/PE
Conductor First
3
Tools Needed:
3/8 in
3/8, 1/2, 7/16 in
230 VOLTS
L L L
380 VOLTS
L L
460 VOLTS
L L L
1
GND/PE
Earth Ground
4
L1 (U)
L2 (V)
Connect GND/PE
Conductor First
460 VOLTS
L L
S-083 566-C
415 VOLTS
L L
S-131 783-A
2
575 VOLTS
L L
S-010 587-B
Check input voltage available at
site.
1 Jumper Link Label
Check label – only one is on unit.
2 Jumper Links
Move jumper links to match input
voltage.
3 Input And Grounding
Conductors
Select size and length using Sec-
tion 3-9.
4 Line Disconnect Device
Select type and size of overcurrent
protection using Section 3-9.
Reinstall side panel.
Y Special installation may be
required where gasoline or
volatile liquids are present –
see NEC Article 511 or CEC
Section 20.
Ref. ST-149 843-C
TM-354 Page 17