Miller Electric STR 350C Owner's Manual page 28

Trouble
Erratic arc with excessive spatter.
Electrode freezing to work.
Low weld output with no control.
Limited output and low open-circuit
voltage.
Notes
OM-249 914 Page 24
Use dry, properly stored electrodes.
Shorten arc length.
Reduce amperage setting.
Increase amperage setting.
Increase arc length.
Use dry, properly stored electrodes.
Check position of Amperage Control (see Section 4-1).
Check incoming power for correct voltage. Replace line fuse if open (see Section 3-13).
Check for proper input and output connections (see Sections 3-8 and/or 3-13).
Remedy
Work like a Pro!
Pros weld and cut
safely. Read the
safety rules at
the beginning
of this manual.