Omega K9-Sombra Owner's Manual & Installation Instructions page 6

STAGE 2: If the alarm has not made contact with the remote (if RFID is "On"),
or received a Valet/Remote button press input from driver it will enter the
second stage of Anti-Carjacking sequence. Stage 2 starts at 46 seconds
after the sequence has started through 75 seconds. During this stage,
the LED will blink fast and the siren will chirp once per 1 second.
IF RFID IS "On": By this time the remote control should have established
contact with the alarm and stopped the Anti-Carjacking sequence, but will
quietly continue to monitor that you are still there while the vehicle's door
is open, and for 3 minutes after the door is closed. If during this search
time, the alarm losses contact with the remote control, the it will restart
Anti-Carjacking sequence.
IF RFID IS "Off": Within this period, If RFID is "Off", the alarm will still be
looking for a manual input press of the Valet button, or a press of the
remote control's button. Once this input is received, the alarm will cancel
the Anti-Carjacking sequence. If the door is closed after receiving input,
the sequence will restart and require another Valet/Remote control input.
NOTE: Depending on how long the vehicle's door is open, it may be neces-
sary to press the Valet button, or the remote control's button while the
door is open, and again after it is closed, because the alarm will start to
search for input again once door is closed. This is to protect against the
car-jacker driving away with the door open thinking that it will not trigger
the system.
- If vehicle's ignition is turned "Off" during stage 2, The alarm will Arm
itself.
STAGE 3: If the Alarm has not received an RFID signal or manual input from
the driver after 75 seconds, Anti-Carjacking mode will enter Full Trigger.
The siren will sound and the parking lights will flash continuously. Once
the vehicle's ignition is turned "Off", the unit will activate the starter
disable.
TO DISARM ANTI-CARJACKING FULL-TRIGGER:
First Step: Turn the vehicle's ignition "Off " .
Second Step: Turn the vehicle's ignition back "On".
Third Step: Within 20 seconds enter your PIN code using the Valet/Override
Switch or Press the button on the Remote control.
- If the remote control battery is low, the alarm will disable Anti-car-jacking.
THEN WITHIN
20 SECONDS
Page 6
ENTER PIN-CODE