NordicTrack 9600 Bike Manual page 22

Press the ENTER AGE/WT. button again and
10
program TV channels.
The console has the capability to find and store in
memory all of the valid TV channels in your area.
While the words "PRESS CHANNEL UP TO
SCAN" appear in the main display, press the
CHANNEL + button to start the channel scanning
process.
The console will begin scanning all TV channels.
If no broadcast signal is detected on a channel,
the channel will be skipped; if a signal is detected,
a tone will sound and the channel will be stored in
memory. This process will continue until the high-
est channel is reached. The lowest channel stored
in memory will then appear in the main display.
Press the ENTER AGE/WT. button again and
11
delete or add TV channels.
After all valid TV channels have been stored in
the console's memory, you can delete unwanted
channels or add channels. To delete or add a
channel, first press the CHANNEL + and – but-
tons until the channel appears in the main display.
To delete a channel, press the + or – button be-
side the ENTER AGE/WT. button so that the
words "CHANNEL SAVED" do not appear next to
the channel. To add a channel, press the + or –
button so that the words "CHANNEL SAVED" ap-
pear next to the channel. Then, select the next
channel that you want to delete or add. Repeat
this process until you have deleted all unwanted
channels and added all desired channels.
Hold down the ENTER AGE/WT. button and
12
the CLEAR button simultaneously for a few
seconds to exit the maintenance mode.
To exit the maintenance mode at any time, hold
down the ENTER AGE/WT. button and the
CLEAR button simultaneously for a few seconds.
21