Preparation; Mmsi Code Programming - Icom IC-M400BB Instruction Manual

2

PREPARATION

MMSI code programming

■
The 9 digit MMSI (Maritime Mobile Service Identity: DSC self
ID) code can be programmed at power ON.
The code is programmed by using the HM-195.
This initial code setting can be performed only once.
After being set, it can be changed by only your dealer
or distributor. If your MMSI code has already been pro-
grammed, this programming is not necessary.
Hold down [PWR](Dial) to turn ON the power.
q
• Three short beeps sound, and "NO DSC MMSI" is displayed.
Push [ENT] to start the MMSI code programming.
w
• Push [CLEAR] twice to cancel the programming, and go to the
normal operating screen. In this case, the transceiver cannot
make a DSC call. To program the MMSI code, turn OFF the
power, then turn it ON again.
Enter your MMSI code in the following manner:
e
• Select a desired number using Dial, or [∫]/[√]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT] or Dial.
2
Repeat step e to enter all 9 digits.
r
After entering the 9 digit code, "FINISH" is automatically
t
selected, and then push [ENT] or Dial to set it.
The "MMSI CONFIRMATION" screen is displayed.
y
Enter your MMSI code again for confirmation.
u
• Enter in the same manner as steps e through t.
When your MMSI code programming is successfully com-
i
pleted, the screen as shown below is briefly displayed.
• After that, the normal operating screen is displayed.
The programmed MMSI code can be checked in the MENU
screen.
NOTE: Depending on the transceiver version, the ATIS
code programming may be required after programming the
MMSI code. See the next page for details.