Yamaha SUPER TENERE XT1200Z Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
Engine trouble warning light "
This warning light comes on or flashes
if a problem is detected in the electrical
circuit monitoring the engine. If this oc-
curs, have a Yamaha dealer check the
self-diagnosis system. (See page 3-14
for an explanation of the self-diagnosis
device.)
3
The electrical circuit of the warning light
can be checked by turning the key to
"ON". The warning light should come
on for a few seconds, and then go off.
If the warning light does not come on
initially when the key is turned to "ON",
or if the warning light remains on, have
a Yamaha dealer check the electrical
circuit.
ABS warning light "
In normal operation, the ABS warning
light comes on when the key is turned
to "ON", and goes off after traveling at a
speed of 10 km/h (6 mi/h) or higher.
If the ABS warning light:
●
does not come on when the key is
turned to "ON"
● comes on or flashes while riding
●
EAU11534 does not go off after traveling at a
"
speed of 10 km/h (6 mi/h) or higher
The ABS may not work correctly. If any
of the above occurs, have a Yamaha
dealer check the system as soon as
possible. (See page 3-20 for an expla-
nation of the ABS.)
WARNING
If the ABS warning light does not go
off after traveling at a speed of 10
km/h (6 mi/h) or higher, or if the
warning light comes on or flashes
while riding, the brake system re-
verts to conventional braking. If ei-
ther of the above occurs, or if the
warning light does not come on at
all, use extra caution to avoid possi-
ble wheel lock during emergency
EAU51661
" braking. Have a Yamaha dealer
ABS
check the brake system and electri-
cal circuits as soon as possible.
TIP
If the start switch is pushed while the
engine is running, the ABS warning
light will come on, but this is not a mal-
function.
Traction control system indica-
tor/warning light "TCS"
This indicator/warning light flashes
when the traction control system en-
gages.
The electrical circuit of the light can be
checked by turning the key to "ON".
EWA16040
The light should come on for a few sec-
onds, and then go off.
If the light does not come on initially
when the key is turned to "ON", or if the
light remains on, have a Yamaha deal-
er check the electrical circuit.
When the traction control system
switch is set to "TCS" modes "1" or "2",
and the traction control system is oper-
ating, the indicator light flashes.
If the traction control system disables
while riding, "TCS" "Off" is displayed,
and the indicator/warning light and en-
gine trouble warning light come on.
(See page 3-21 for an explanation of
the traction control system.)
3-7
EAU49402