Kenwood TK-3202 Service Manual page 7

3. Attaching the antenna receptacle to the
chassis.
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle comes
to the center of the case hole.
Tighten this screw first.
Tighten this screw second.
4. The nuts of the volume knob and channel
knob
Note that the shapes, colors and heights of nuts of the
volume knob and channel knob are different from one
another. (The nut of volume knob is silver, and the nut of
channel knob is gold)
Use the following jig when removing the nuts of the
volume knob and channel knob.
Jig (Part No. : W05-1012-00)
Volume Knob
(Silver)
DISASSEMBLY FOR REPAIR
Channel Knob
(Gold)
TK-3202/3206
5. Screw sequence for mounting the TX-RX unit
to the chassis.
Attach the TX-RX unit to the chassis using the screws in
the order shown in the drawing below.
_
7
_
8
_
9
TX-RX UNIT
Component side view
_
10
_
5
_
6
_ _
1 4
_ _
2 3
_
11
7