Kenwood TK-3202 Service Manual page 6

TK-3202/3206
Assembling the battery release lever
x
1. Place the lever onto the stopper
2. Place the thick spring
3. Hook the right and left ends of the thin spring
tabs of the stopper, then place the thin spring onto the
b
lever .
4. Slide the shaft through the hole of the stopper and lever
n
.
4
3
5
2
1
Cautions for assembly
1. Attaching the positive terminal to the chassis.
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly
the positive terminal.
2. Mount the packing of the positive terminal into the chassis
c
hole .
3. Mount the holder assembly into the packing of the positive
v
terminal .
2
1
4
6
DISASSEMBLY FOR REPAIR
z
.
c
onto the lever.
v
onto the
6
x
from the packing
3
2. Mounting the chassis to the case assembly.
1. Confirm that the waterproof packing attached to the
circumference of the chassis is securely inserted in the
groove of the chassis
2. Twist the speaker wires twice, then attach the speaker to
the speaker recess of the case assembly
the speaker is securely inserted.
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
3. Insert the upper part of the chassis into the case assembly
c
.
Caution: Take care that the speaker lead wire is not caught
by the microphone element.
4. Press the chassis
attach them.
z Caution: If the packing of the SP / MIC does not come to the
of
correct position after attaching the chassis to the
case assembly, reposition the packing with your
fingers.
z
.
x
2
1
v
and the case assembly together to
3
4
4
. Make sure