Equalizer Control - Kenwood DNX7310BT Instruction Manual

Return to the Top page
Audio Setting Up

Equalizer Control

You can adjust equalizer by selecting the
optimized setting for each category.
If you use , you can also adjust
equalizer manually.
1
Touch [Equalizer].
Equalizer screen appears.
operation
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
[Powerful], [iPod], and [User].
NOTE
• [iPod] is available only during iPod source.
88 88
Controlling equalizer manually
This setting cannot be performed when you
select [iPod] in the Equalizer screen.
1
Touch [EQ] in the Equalizer screen.
2
Touch the screen and set the Graphic
Equalizer as desired.
Gain level (light green boxed area)
Adjust the gain level by touching the each
frequency bar.
Touching [2], [3], [5] and [∞] can also
adjust the level. Use [2] and [3] to select a
frequency, and [5] and [∞] to set the level.
EQ INIT
Returns to the previous level which the gain
level is adjusted.
Flat
Tone curve becomes flat.
Bass EXT (Bass Extend Settings)
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5 Hz.
Loudness
When turned on, low and high tones are
enhanced.
Highway Sound
Boosts a certain range of sound that becomes
hard to hear due to road noise. See Highway
sound setting (P.89).
SW Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to "None".
See Speaker setup (P.82).
Highway sound setting
You can boost a certain range of sound that
becomes hard to hear due to road noise.
1
Touch [Highway Sound] in the Graphic
Equalizer screen.
Highway Sound screen appears.
2
Select the boost level from among
[High], [Low], and [OFF].
operation
Controlling EQ curves
1
Select EQ curve from [Natural],
[Rock], [Pops], [Easy], [Top40], [Jazz],
and [User] using [2] and [3].
Controlling SystemQ-Ex
Selects items to be adjusted for tone curve
setup. If you turn off this setting, only Level
can be set up for tone curves.
1
Touch [ON] or [OFF] of [SystemQ-Ex].
Return to the Top page
Audio Setting Up
Controlling equalizer manually
1
Touch [Tone] in the Equalizer screen.
2
Set each item as follows.
FREQ
Adjusts the center frequency for each range.
Setting values are as follows.
Bass: 4 0Hz/50Hz/60Hz/70Hz/80Hz/100Hz/120
Hz/150Hz (Default is "100Hz".)
Middle: 5 00Hz/1kHz/1.5kHz/2kHz (Default is
"1kHz".)
Treble: 1 0kHz/12.5kHz/15kHz/17.5kHz (Default
is "12.5kHz".)
LEVEL
Adjusts the level of each range.
Each setting value is within -8dB and 8dB and
default is "0dB".
Q Factor
Adjust Q value for bass and middle.
Setting values are as follows.
Bass: 1/1.25/1.5/2 (Default is "1".)
Middle: 1/2 (Default is "1".)
Bass DC EXT
Turns Bass DC EXT on or off. Default is "OFF".
If you select "ON", the bass center frequency is
extended to the low register by approximately
20%.
[Flat]
Tone level becomes 0 (flat).
Subwoofer Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to "OFF".
See Speaker setup (P.82).
89