Kenwood DNX7310BT Instruction Manual page 43

Return to the Top page
Audio Setting Up
Crossover network setup
You can set a crossover frequency of
speakers.
1
Touch the speaker to set the crossover
in the Speaker Select screen.
2
Touch [X'over].
X'over screen appears.
3
Set each item as follows.
Phase*
Sets the phase of subwoofer output.
The phase is reversed 180 degrees when set to
"Reverse".
HPF FREQ
High Pass Filter adjustment. (When front or rear
speaker is selected on Speaker Select screen)
LPF FREQ
Low Pass Filter adjustment. (When subwoofer
is selected on Speaker Select screen)
Slope
Sets a crossover slope.
* T his function is available in the specific
situation.
Only when "Subwoofer" is
set to other than "None" in "Speaker Setup".
Only when "Subwoofer" is set to
"ON" in "Speaker Setup" and "LPF FREQ" is
set to other than "Through".
84 84
When Speaker network is set to 3 way
(DNX7310BT/ DDX7031BT):
Range switching area (graph)
Selects the band for setting gain, frequency
filter, and slope.
Touch the left arc to set the LPF, the center arc
to set the BPF, and the right arc to set the HPF.
Phase*
Sets the phase of tweeter, mid range, and
woofer output.
The phase is reversed 180 degrees when set to
"Reverse".
Gain
Sets gain of each speaker.
HPF FREQ
High Pass Filter adjustment. (When tweeter is
selected on Speaker Select screen)
BPF FREQ
Band Pass Filter adjustment. (When mid range
speaker is selected on Speaker Select screen)
LPF FREQ
Low Pass Filter adjustment. (When woofer is
selected on Speaker Select screen)
Slope
Sets a crossover slope.
* O nly when "Subwoofer" is set to "ON" in
"Speaker Setup".
NOTE
• For how to switch to the 3-way speaker system,
3 way speaker system setup (P.32)
see
in the Quick Start Guide. Connecting 3-way
speakers with the 2-way mode selected can break
the speakers.
Car type setup
You can setup the car type and speaker
network, etc.
1
Touch [Car Type] in the Audio SETUP
screen.
Car Type screen appears.
2
Select your car type from the list.
NOTE
• If your car type is selected, the Delay Time
Alignment is set automatically (for timing
adjustment of sound output for each channel) to
have the highest surround effects.
Return to the Top page
Audio Setting Up
Speaker location setup
1
In the Car Type screen, touch
[Location].
Speaker Location screen appears.
2
Select the speaker locations using
[3].
Front Speaker
Select the location from "Door"/ "On Dash"/
"Under Dash".
Rear Speaker
Select the location from "Door"/ "Rear Deck",
"2nd Row"/ "3rd Row" (Minivan, Minivan
(Long)).
When Speaker network is set to 3 way
(DNX7310BT/ DDX7031BT):
Mid Range
Select the location from "Door"/ "On Dash"/
"Under Dash".
85