CAL POSOUT Group
The CAL POSOUT group is used to verify that the position sensor is operating and adjusted properly. This
group allows the local display to indicate the output voltage of the position sensor. This display is used
when verifying the POS sensor is operating and that it is properly calibrated. Table 23 shows the selections
available for the CAL POSOUT group.
Actuator Lower
Display
Prompt
CALPOS
To access the display...
Revision 6
HercuLine™ 2000 Series Actuator - Installation, Operation and Maintenance Manual
7/07
Table 23 CAL POSOUT Group Parameters
Selections or
Range of Setting
POSITION SENSOR OUTPUT — Read Only. Displays the
n.nnn
output voltage of the position sensor
Press
SETUP
Upper Display =
Lower Display =
until you see
FUNCTION
Upper Display =
Lower Display =
Upper Display =
or
key
Lower Display =
FUNCTION
Upper Display =
Lower Display =
Set Up and Calibration Procedures
Parameter Definition/PDA HercuLink Prompt
Result
CAL
POSOUT
DIS
CALPOS
BEGN
CALPOS
n.nnn
POSOUT
CAL POSOUT Group
(sensor output in volts)
63