Weber Summit 4 BURNER Operating Manual page 15

MAINTENANCE
10. Slide the burner assembly from each Heat Zone. The
left and right burners are connected by the Crossover
tube. Figure 14 (a).
(a)
Crossover tube
11. Lift and twist the burner assembly slightly to separate
the crossover tube from the burners. Remove the
burners from the cooking box. Figure 15.
Pull out of here
Figure 14
Separate here
Crossover tube
Figure 15
12. To reinstall the burners, reverse steps 3 through 11.
CAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 16 (a).
Check proper assembly before fastening manifold in
place. Figure 16 (b).
(a)
Burner
Orifice
(b)
13. Reinstall the Spider Stopper Guards. Slightly rotate
the Spider Stopper Guards so that the seams are in
line with the Venturi fins. There should be no gaps in
the seams or in the fit around the burners and valves.
Figure 17.
Venturi fin
15
Valve
Figure 16
Check fit
around valve
Check fit around burner
Figure 17