When The Lamp Of Indoor Unit Blinks - Toshiba RAS-10JKCVP Series Owner's Manual

When the lamp of indoor unit blinks

Turns off power supply and turns on again after 30 seconds and check operation of the unit
PRESET
MODE SWING
AIR FLOW
FIX
ECO
COMFORT
PURE
SLEEP
ON OFF SET
CLOCK CHECK FILTER
32
1110650159_(31-38)_EN.indd 32 1110650159_(31-38)_EN.indd 32
If the lamp blinks again, inspection and repair is required
To repair quickly, check the status of the air conditioner according to the following procedure
and inform below (1) – (3) to the dealer or the Toshiba Service Center.
1
Symptoms of the air conditioner
2
Check code found by the remote controller (See process below).
3
Blinks status of the lamp in the display portion of the indoor unit
1
Press the CHECK button with a tip of pencil to set the remote
controller to the service mode.
•
Setting temperature display switches to 00.
•
2
Press
TEMP.
•
is displayed in remote controller display.
•
Press [
If there is no fault with a code, the indoor unit will Pi once (Pi) and the display of the remote controller will
change as follows :
TEMP.
• The TIMER indicator of the indoor unit fl ashes continuously. (5 times per 1 sec.)
FAN
• Check the unit with all 52 check code (
FIX
• Press [
Hi POWER
If there is a fault, the indoor unit will Pi for 10 seconds (Pi, Pi, Pi ...).
POWER-SEL
Note the check code on the display of the remote controller.
• 2-digits alphanumeric will be indicated on the display.
CLR
• All indicators on the indoor unit will fl ash. (5 times per 1 sec.)
RESET
3
Press
•
Remote display returns to the display before the service mode. However, check codes remain in the Indoor
unit.
Notes
•
Check codes may not be displayed depending on the kind of fault such as an electrical parts fault.
•
If the check codes are checked when the lamp is not blinking, the correct error code may not be displayed.
•
Do not disassemble or repair yourself. Consult the dealer or the Toshiba Service Center.
Check Codes Table
Check codes not listed in the table may be detected.
Abnormal indoor unit (including wiring fault).
Abnormal outdoor unit (including compressor and others).
is displayed.
] or [ ] on button.
TEMP.
to
] or [ ] on button to change the check code backward.
TEMP.
to release it
) as shown in Table 11-4-1.
Check codes consist of digits and
letters.
2/28/11 2:11 PM 2/28/11 2:11 PM