Table of Contents
Advertisement
Angle Adjustment
For this procedure, refer to FIGURE 4 on page 54
and FIGURE 5.
Observe the angle of the footplate for reinstallation.
The settings for positioning the footplates on the
half-clamps may vary for each footplate.
1.
Loosen, but DO NOT remove, the two flat screws, washer and
locknuts that secure the footplate to the footplate hinge
(FIGURE 4).
2.
Position the footplate to the necessary angle to accommodate the
user (FIGURE 5).
3.
Retighten the two flat screws, washers and locknuts.
Perpendicular and/or Inversion/Eversion Adjustment
For this procedure, refer to FIGURE 4 on page 54
and FIGURE 6.
It is not necessary to remove the footplate to
perform this adjustment.
1.
Insert a flathead screwdriver through the half clamp on the
footplate (FIGURE 4).
2.
Slowly turn nylon adjustment screw in or out until footplate is
perpendicular to the footrest assembly or the desired inversion or
eversion is obtained (FIGURE 6).
Part No 1143192
Footrest Support
Footplate
FIGURE 5
Front View of Footplate
and Footrest Support
FIGURE 6
Perpendicular and/or Inversion/Eversion Adjustment
55
6 ADJUSTMENT
Side View of
Footplate and
Footrest
Support
Angle Adjustment
Footrest Support
Footplate
Invacare® Adjustable ASBA Seats
Advertisement
Table of Contents
