FRONT RIGGING SUPPORT MOUNTING POSITIONS
STANDARD POSITION
18 & 20-Inches
22 & 24-Inches
Wide
Holes 2 and 3
Holes 4 and 5
FIGURE 6.6 Adjusting/Replacing Telescoping Front Rigging Supports
ASBA
NOTE: For this procedure, refer to FIGURE 6.7 on page 76.
1. Remove the two mounting screws, spacers and locknuts that secure the telescoping
front rigging support to the seat frame.
2. Perform one of the following:
• Slide existing telescoping front rigging support to one of three depth positions.
• Remove existing telescoping front rigging.
3. Secure telescoping front rigging at desired depth with existing two mounting screws,
spacers, and locknuts. Securely tighten.
NOTE: The two telescoping front rigging supports can be positioned at different depths depending
on the need of the user.
Part No. 1125038
Middle Mounting
Holes
Seat
Frame
1-INCH OUT
18 & 20-Inches
Wide
Wide
Holes 3 and 4
SECTION 6—FRONT RIGGINGS
Not Used
Telescoping Front
Spacer
8
Locknuts
22 & 24-Inches
18 & 20-Inches
Wide
Holes 5 and 6
Holes 4 and 5
75
Socket Bolts
Rigging Support
Mounting
Holes
7
5
6
4 3
2
Hinge
Not Used
Pins
2-INCHES OUT
22 & 24-Inches
Wide
Wide
Holes 6 and 7
®
Pronto
M91™and M94™