SECTION 6—REAR WHEELS
SECTION 6—REAR WHEELS
After any adjustments, repair or service and before use, make sure all attaching hardware is
tightened securely. Otherwise, injury or damage could result.
As with any vehicle, the wheels and tires should be checked periodically for cracks and wear, and
should be replaced.
Removing/Installing Rear Wheels
NOTE: For this procedure, refer to FIGURE 6.1.
1.
Remove the dust cap (if applicable), hex screw and locknut that secure the rear wheel and axle spacer to the transport
chair.
2.
Repeat STEP 1 for the opposite rear wheel.
3.
To reinstall the rear wheels onto the transport chair, reverse STEPS 1‐2.
NOTE: Make sure the axle spacer is between the rear wheel and the transport chair frame.
NOTE: Rear wheel shown for Invacare Transport and Lightweight Transport. Dust cap for Bariatric Transport
and Lite Transport not shown.
Transport Chairs
CAUTION
Axle Spacer
Rear Wheel
Hex Screw
FIGURE 6.1 Removing/Installing Rear Wheels
WARNING
18
Locknut
Axle Mounting
Hole
Part No.1125095