Invacare Tracer IV Heavy Duty User Manual page 52

Anti-tippers/Wheel Locks
Installing Anti-Tippers
1. Press the release buttons and insert the anti-tippers with the anti-tipper wheels pointing toward the ground/floor into the wheelchair frame
tubing.
2. Ensure that the release button of the anti-tipper fully protrudes out of the hole in the bottom of the wheelchair frame tubing.
3. Place the wheelchair on a flat surface.
4. Measure the distance between the bottom of the anti-tipper wheels and the ground/floor.

1
A 1 / to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all
2
times.
5. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 1
Anti-Tippers on page 53.
Invacare® Tracer IV®Heavy Duty/Extra Wide Wheelchair
Anti-Tipper
Wheels
Anti-Tipper
Release Buttons
FIGURE 1 Installing Anti-Tippers
1
/ to 2-inches, adjust anti-tippers. Refer to Adjusting the
2
Anti-Rattle
Rear Frame
Tubing
52
Part No. 1110558