Invacare Tracer IV Heavy Duty User Manual page 37

Bolt-In-Place Height
 This procedure applies to the swingaway footrests
and swingaway elevating legrest.
1. Remove the swingaway front rigging. Refer to
Installing/Removing Front Riggings on page 34.
 Lay the front rigging assembly on a flat surface to
simplify this procedure.
2. Pull the cam lock lever up to the unlocked position.
3. Using a screw driver to hold the threaded rivet in position, remove
the button head screw from the threaded rivet.
4. Remove the threaded rivet and button head screw securing the
footplate assembly to the front rigging support.
5. Adjust the footplate assembly height by aligning the desired
adjustment holes in the upper front rigging support and lower
footplate assembly.
6. From the outside of the swingaway front rigging, insert the
threaded rivet through both the front rigging support and the
footplate assembly.
7. From the inside of the swingaway front rigging, insert the button
head screw through the appropriate adjustment hole and thread
into the threaded rivet.
8. Using a screwdriver to hold the threaded rivet in position, securely
tighten the button head screw. Torque to 32 in-lbs.
9. Rotate cam lock lever down to locked position.
10. Repeat STEPS 1-9 to adjust the remaining footrest.
Part No. 1110558
Button Head
Screw
Cam Lock
Lever
Inside of
Swingaway Front
Rigging
Front Rigging
Support
Button
Head Screw
Adjustment Hole

Swingaway footrest shown.
FIGURE 3 Bolt-In-Place Height
37
Invacare® Tracer IV®Heavy Duty/Extra Wide Wheelchair
5 FRONT RIGGINGS
Front Rigging Support
Threaded Rivet
Adjustment
Hole
Footplate
Assembly
Outside of
Swingaway Front
Rigging
Threaded
Rivet
Footplate
Assembly