Jenn-Air 30" (76.2 CM) Installation Instructions Manual page 13

5. Mount blower motor to the floor with 4 - #8 x ¾" hex head
screws provided.
6. Go to the "Electrical Connection" section.
Floor Venting
1. Mark the floor at the center of the cabinet opening.
2. Position template on floor by matching the centerline of the
template to the centerline drawn on the floor and place
template 2¼" (5.7 cm) from the back wall.
3. Determine the correct position for the vent hole, depending
on obstructions (joists) in the floor.
The hole can be cut anywhere within the boundaries of the
larger hatched area.
The blower inlet must face the left side as shown on the
template.
A
A. Inlet from range
B. Exhaust outlet
Top View
Top View
B
NOTE: If the template is misplaced, the following
measurements can be used to determine the vent hole
location.
A
A. 9" (22.8 cm)
B. 3 " (7.9 cm)
C. 6 " (16.2 cm)
4. Draw and cut a 6¼" (15.8 cm) diameter hole.
5. Position blower motor in cabinet opening and mount blower
motor to the floor.
B
A
A. Inlet from range
B. Exhaust outlet
Top View
B
C
D
E
F
D. 2¼" (5.7 cm)
E. 12½" (31.7 cm)
F. 3½" (8.9 cm)
Top View
13