Entering The Administration Menu Password - HP Surestore Tape Library Model 2/28 User Manual

Entering the Administration Menu
Password
1 2 3 4
A numeric password is required to access options beneath ADMIN* menu of
the library (see Figure 4-2 on page 4-6). A three-part password of 000-000-000
is set at the factory. To allow only authorized persons to access the library
and change operation settings, the password must be changed.
NOTE To change the password, see "Setting a New Administration Menu Password"
on page 4-8.
Do not forget the password. Only an HP qualified service representative can
reset the security code to the factory setting.
To enter the password:
1. Verify that the drive status displays (if not, press
2. Press
3. PSWD 000-000-000 displays, and the first set of zeros flashes.
4. The middle set of zeros flashes.
5. The last set of zeros flashes.
To access options under the ADMIN* menu, press
desired option displays, then press
ADMIN* PSWD 000-000-000
until ADMIN* displays, then press
NEXT
Press to accept this number (if no password has been set), or press
ENTER
or until the set number displays. Press
NEXT PREV
Press to accept this number (if no password has been set), or press
ENTER
or until the set number displays. Press
NEXT PREV
Press to accept this number (if no password has been set), or press
ENTER
or until the set number displays. Press
NEXT PREV

Entering the Administration Menu Password

CONFIG*
CANCEL
.
ENTER
.
ENTER
.
ENTER
. INFO* displays.
ENTER
or
PREV NEXT
.
ENTER
Library Operation
until it does).
until the
4-7