Set Ipconfig; Set Snmp Community - HP Integrity Superdome 2 16-socket User Manual

Access level/Bay level:
All
Restrictions:
None

SET IPCONFIG

Command:
SET IPCONFIG {DHCP | STATIC} [<OA bay number>] [DYNAMICDNS] <ip address>
<netmask> [<gateway> [<DNS1address> [<DNS2 address>]]]
Description:
◦
Configures IP settings for the Onboard Administrator to DHCP mode or static mode.
◦
In STATIC mode, the IP address and Netmask are set to <ip address> and <netmask>
respectively. These settings take effect immediately. If the Gateway address or DNS
address or both are cleared, they are omitted. The Gateway and DNS addresses can
also be set by using the SET OA GATEWAY and ADD OA DNS commands.
◦
To configure in STATIC mode, use the following command format:
SET IPCONFIG STATIC [<OA bay number>] <ip address> <netmask> [<gateway> [<DNS1address> [<DNS2
address>]]]
◦
In DHCP mode, the IP address, Netmask, Gateway address, and DNS addresses are
obtained from the DHCP. This setting immediately takes effect. If DYNAMICDNS is specified,
then the DNS server is notified of the new IP address of the system when it is received
from the DHCP server.
◦
To configure in DHCP mode, use the following command format:
SET IPCONFIG DHCP [<OA bay number>] [DYNAMICDNS]
Access level/Bay level:
OA Administrator, OA Operator
Restrictions:
None

SET SNMP COMMUNITY

Command:
SET SNMP COMMUNITY {READ | WRITE} "<community name>"
Description:
Sets the community name for the read or write SNMP community. If a blank write community
name is given, then SNMP set commands are disabled until a non-empty community name is
given.
Access level/Bay level:
OA Administrator, OA Operator
Restrictions:
◦
The write <community name> must be no more than 20 characters long, and the read
<community name> must be must be no more than 20 characters long.
◦
All printable characters are valid.
66 Enclosure network configuration commands