Single-Port 2Xp Pci; 2Xp Pci Card Specifications; 2Xp Pci Card Physical Characteristics - HP Cluster Platform Interconnects v2010 Manual

Table 2-3 describes the technical specifications for the 2XP PCI card.
Table 2-3: 2XP PCI Card Specifications
Feature
2XP PCI card
Bus speed
Local memory
Memory bandwidth
Processor
Fiber port physical
Fiber port data rate
EEPROM
Table 2-4 describes the physical and environmental characteristics of the 2XP
PCI card.
Table 2-4: 2XP PCI Card Physical Characteristics
Characteristic
Dimensions (excluding faceplate)
Mass
Power requirement
Environmental, operating
Environmental, nonoperating

2.4 Single-port 2XP PCI

The single-port 2XP PCI NIC (Figure 2-4) is the Myricom Rev. F card. It supports
one X-port interface and one PCI-X interface. These NICS must use the Myricom
GM-2 or Myrinet Express (MX) software.
Other than the difference in the number of ports, the Rev. F card has the same
specifications as the Rev. E card.
Specifications
64-bit PCI-X and PCI
protocols
66-133 MHz
2 MB
2664 MB/s
333 MHz RISC
LC-type optical connector,
50/125 multimode fiber pair
2.0+2.0 Gb/s data rate,
2.5+2.5 GBaud signaling,
8b-10/b encoded
512 KB
Specifications
6.4 cm high, 16.4 cm long, 2.2 cm thick
(low-profile PCI short card)
82g (including the faceplate)
3.3V from the PCI bus, 2.0A (6.6W) maximum
0C to 50C up to 10,000 foot altitude
Relative humidity 15% to 80% @ 50C
-40C to 70C
Relative humidity 90% @ 65C
Notes
Can be used in any 3.3V PCI
slot.
Capable of peak PCI
date rates at the limits
of the PCI-X or PCI buses
(1067MB for 64-bit, 133MHz
PCI-X and 533MB for 64-bit
at 66 MHz).
LANai 2XP.
Class I Laser Product (no
hazard).
The standard firmware
distributes packets
adaptively across the
two ports, such that the two
ports act as a single 4.0+4.0
Gb/s data-rate port.
Includes the PCI-
configuration-space data,
such as serial number,
MAC address, and product
code. The EEPROM can be
reprogrammed by the 2XP.
PCI cards 2-5