HP Cisco Catalyst Blade Switch 3020 Release Note page 25

Cisco gigabit ethernet switch module for hp bladesystem p-class release notes cisco ios release 12.2(44)se1 and later
Hide thumbs Also See for Cisco Catalyst Blade Switch 3020:
Table of Contents

Advertisement

System Messages Guide
These are the documentation updates for the system modesties guide:
New System Messages
These system messages have been added.
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars]
Error Message SPANTREE-6-PORTADD_ALL_VLANS: [chars] added to all Vlans
Error Message SPANTREE-6-PORTDEL_ALL_VLANS: [chars] deleted from all Vlans
Error Message SW_VLAN-6-VTP_DOMAIN_NAME_CHG: VTP domain name changed to [chars].
Error Message VQPCLIENT-2-TOOMANY: Interface [chars] shutdown by active host limit.
Cisco Gigabit Ethernet Switch Module for HP BladeSystem p-Class Release Notes, Cisco IOS Release 12.2(44)SE and Later
464831-005
New System Messages, page 25
Changed System Messages, page 26
Explanation
The client MAC address could not be added to the MAC address table because the
hardware memory is full or the address is a secure address on another port. [enet] is the supplicant
MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is
enabled.
Recommended Action
If the hardware memory is full, remove some of the dynamic MAC addresses.
If the client address is on another port, manually remove it from that port.
The interface has been added to all VLANs. [chars] is the added interface.
Explanation
No action is required.
Recommended Action
The interface has been deleted from all VLANs. [chars] is the deleted interface.
Explanation
Recommended Action
No action is required.
The VLAN Trunking Protocol (VTP) domain name was changed through the
Explanation
configuration to the name specified in the message. [chars] is the changed domain name.
No action is required.
Recommended Action
The system has shut down the specified interface because too many hosts have requested
Explanation
access to that interface. [chars] is the interface name.
To enable the interface, remove the excess hosts, and enter the no shutdown
Recommended Action
interface configuration command.
Documentation Updates
25

Advertisement

Table of Contents
loading

Table of Contents