HP Carrier-grade cc2300 Safety And Regulatory Information Manual page 9

Cabinet Safety Precautions
WARNING Cabinets are heavy even when empty. Exercise caution when moving cabinets whether
equipment is installed in the cabinet or not. Avoid rolling cabinets on rough or uneven
surfaces or inclines greater than 10 degrees. Unloading cabinets from the pallet and
movement of cabinets should be performed by at least two people.
WARNING Slideable products are not to be extended from the cabinet while the equipment is on the
shipping pallet. The cabinet must be unloaded from the pallet and both front and rear anti-tip
feet properly installed prior to extending any slideable product.
WARNING Once installed, both the front and rear anti-tip feet must remain in place to maintain stability.
Only one slideable product must be extended at a time.
WARNING Use of any slide mount product requires the installation of a cabinet anti-tip device.
The anti-tip device for the following cabinet products is a pair of anti-tip feet: A4900A,
A4901A, A4902A, A5134A, A5135A, A5136A, J1500A, J1501A, and J1502A.
Install both front and rear anti-tip feet on the cabinet before installing any slide mount
product.
The anti-tip device for the following cabinets is the installation of ballast in the bottom of the
cabinet: A1896A, A1897A, A1883A, A1884A, C2785A, C2786A, and C2787A.
To determine ballast requirements, refer to the ballast worksheets in documentation
accompanying the cabinet or http://www.hp.com/racksolutions/prodinfo/index.html.
Failure to follow these precautions can result in damage to equipment or injury to personnel.
HP Carrier Grade Server Safety and Regulatory Information
English 7