Log Destinations; Default Log Output Rules; Log Format - HP 6125XLG Configuration Manual

Severity
value
3
4
5
6
7

Log destinations

The system outputs logs to the following destinations: console, monitor terminal, log buffer, log host, and
log file. Log output destinations are independent and you can configure them after enabling the
information center.

Default log output rules

A default output rule specifies the log source modules and severity level for an output destination. Logs
matching the output rule are output to the destination.
Table 7 Default output rules
Destination
Console
Monitor terminal
Log host
Log buffer
Log file

Log format

The format of logs varies with output destinations.
which might be different from what you see. The actual format depends on the log resolution tool used.
Table 8 Log formats
Output destination
Console, monitor
terminal, log buffer, or
log file
Level Description
Error Error condition. For example, the link state changes.
Warning condition. For example, an interface is disconnected, or the memory
Warning
resources are used up.
Normal but significant condition. For example, a terminal logs in to the device,
Notification
or the device reboots.
Informational message. For example, a command or a ping operation is
Informational
executed.
Debug Debug message.
Log source modules
All supported modules
All supported modules
All supported modules
All supported modules
All supported modules
Format
Prefix Timestamp Sysname
Module/Level/Digest: Content
Table 7 shows the default output rules.
Output switch
Enabled
Enabled
Enabled
Enabled
Enabled
Table 8 shows the original format of log information,
53
Severity
Debug
Informational
Informational
Informational
Informational
Example
%Nov 24 14:21:43:502 2010 HP
SYSLOG/6/SYSLOG_RESTART:
System restarted –-
HP Comware Software.