Configuring Access Control Rights; Configuring Ntp Authentication; Configuring Ntp Authentication In Client/Server Mode - HP 6125XLG Configuration Manual

Step
3. Configure the device to
operate in multicast server
mode.

Configuring access control rights

Before you configure the NTP service access control right to the local device, create and configure an
ACL associated with the access control right. For more information about ACL, see ACL and QoS
Configuration Guide.
To configure access control rights:
Step
1. Enter system view.
2. Configure the NTP service
access control right for a peer
device to access the local
device.

Configuring NTP authentication

This section provides instructions for configuring NTP authentication.

Configuring NTP authentication in client/server mode

When you configure NTP authentication in client/server mode, enable NTP authentication, configure an
authentication key, set the key as a trusted key on both client and server, and associate the key with the
Command
•
Configure the device to operate
in multicast server mode:
ntp-service multicast-server
[ ip-address ]
[ authentication-keyid keyid |
ttl ttl-number | version number ]
*
•
Configure the device to operate
in multicast server mode:
ntp-service ipv6
multicast-server
ipv6-multicast-address
[ authentication-keyid keyid |
ttl ttl-number ] *
Command
system-view
•
Configure the NTP service
access control right for a peer
device to access the local
device
ntp-service access { peer |
query | server |
synchronization } acl-number
•
Configure the IPv6 NTP service
access control right for a peer
device to access the local
device
ntp-service ipv6 { peer | query
| server | synchronization } acl
acl-number
17
Remarks
By default, the device does not
operate in multicast server mode.
After you execute the command,
the device sends NTP multicast
messages from the specified VLAN
interface.
Remarks
N/A
By default, the NTP service access
control right for a peer device to
access the local device is peer.