HP 6125XLG Configuration Manual page 95

Device
Switch C
Switch D
Switch D
Switch D
Switch E
Switch E
Switch E
Switch E
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to
shown.)
2. Enable OSPF on all switches on the PIM-SM network to make sure the network-layer on the PIM-SM
network is interoperable and the routing information among the switches can be dynamically
updated. (Details not shown.)
3. Enable IP multicast routing, and enable IGMP and PIM-SM:
# On Switch A, enable IP multicast routing globally, enable IGMP on VLAN-interface 100, and
enable PIM-SM on each interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] pim sm
[SwitchA-Vlan-interface101] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim sm
[SwitchA-Vlan-interface102] quit
# Enable IP multicast routing, IGMP, and PIM-SM on Switch B and Switch C in the same way.
(Details not shown.)
# Enable IP multicast routing and PIM-SM on Switch D and Switch E in the same way. (Details not
shown.)
4. Configure C-BSRs and C-RPs:
# On Switch D, configure the service scope of RP advertisements, configure VLAN-interface 105
as a C-BSR and a C-RP, and set the hash mask length to 32 and the priority of the C-BSR to 10.
<SwitchD> system-view
[SwitchD] acl number 2005
[SwitchD-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SwitchD-acl-basic-2005] quit
[SwitchD] pim
[SwitchD-pim] c-bsr 192.168.4.2 hash-length 32 priority 10
Interface
VLAN-interface 104
VLAN-interface 300
VLAN-interface 101
VLAN-interface 105
VLAN-interface 104
VLAN-interface 103
VLAN-interface 102
VLAN-interface 105
88
IP address
192.168.3.1/24
10.110.5.1/24
192.168.1.2/24
192.168.4.2/24
192.168.3.2/24
192.168.2.2/24
192.168.9.2/24
192.168.4.1/24
Figure 33. (Details not