HP 6125XLG Configuration Manual page 170

Table 10 Interface and IPv6 address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Switch D
Switch D
Switch D
Switch D
Configuration procedure
1. Assign the IPv6 address and prefix length to each interface according to
shown.)
2. Configure OSPFv3 on the switches in the IPv6 PIM-DM domain to make sure they are interoperable
at the network layer and routing information among the switches is dynamically updated. (Details
not shown.)
3. Enable IPv6 multicast routing, MLD, and IPv6 PIM-DM:
# On Switch A, enable IPv6 multicast routing, enable MLD on VLAN-interface 100, and enable
IPv6 PIM-DM on each interface.
<SwitchA> system-view
[SwitchA] ipv6 multicast routing-enable
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] ipv6 pim dm
[SwitchA-Vlan-interface100] quit
[SwitchA] interface vlan-interface 103
[SwitchA-Vlan-interface103] ipv6 pim dm
[SwitchA-Vlan-interface103] quit
# Enable IPv6 multicast routing, MLD, and IPv6 PIM-DM on Switch B and Switch C in the same way.
(Details not shown.)
# On Switch D, enable IPv6 multicast routing, and enable IPv6 PIM-DM on each interface.
<SwitchD> system-view
[SwitchD] ipv6 multicast routing-enable
[SwitchD] interface vlan-interface 300
[SwitchD-Vlan-interface300] ipv6 pim dm
[SwitchD-Vlan-interface300] quit
[SwitchD] interface vlan-interface 103
[SwitchD-Vlan-interface103] ipv6 pim dm
[SwitchD-Vlan-interface103] quit
[SwitchD] interface vlan-interface 101
Interface
VLAN-interface 100
VLAN-interface 103
VLAN-interface 200
VLAN-interface 101
VLAN-interface 200
VLAN-interface 102
VLAN-interface 300
VLAN-interface 103
VLAN-interface 101
VLAN-interface 102
163
IPv6 address
1001::1/64
1002::1/64
2001::1/64
2002::1/64
2001::2/64
3001::1/64
4001::1/64
1002::2/64
2002::2/64
3001::2/64
Figure 53. (Details not