Setting Aging Timers For Dynamic Ports; Configuring Static Ports - HP 6125XLG Configuration Manual

Enable MLD snooping for the VLAN.
•
• Determine the aging timer for dynamic router ports.
Determine the aging timer for dynamic member ports.
•
Determine the addresses of the IPv6 multicast group and IPv6 multicast source.
•

Setting aging timers for dynamic ports

When you set aging timers for dynamic ports, follow these guidelines:
If the memberships of IPv6 multicast groups frequently change, set a relatively small value for the
•
aging timer of the dynamic member ports. If the memberships of IPv6 multicast groups rarely
change, you can set a relatively large value.
If a dynamic router port receives an IPv6 PIMv2 hello message, the aging timer for the port is the
•
timer in the hello message rather than the timer set in the mld-snooping router-aging-time
command on the local device.
You can set the aging timers for dynamic ports either for the current VLAN in VLAN view or globally
•
for all VLANs in MLD-snooping view. If configurations are made in both VLAN view and
MLD-snooping view, the configuration made in VLAN view takes priority.
Setting the aging timers for dynamic ports globally
Step
1. Enter system view.
2. Enter MLD-snooping view.
3. Set the aging timer for
dynamic router ports globally.
4. Set the aging timer for
dynamic member ports
globally.
Setting the aging timers for the dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for
the dynamic router ports
in the VLAN.
4. Set the aging timer for
the dynamic member
ports in the VLAN.

Configuring static ports

If all hosts attached to a port are interested in the IPv6 multicast data addressed to a particular IPv6
multicast group or the IPv6 multicast data that a particular IPv6 multicast source sends to a particular IPv6
Command
system-view
mld-snooping
router-aging-time interval
host-aging-time interval
Command
system-view
vlan vlan-id
mld-snooping router-aging-time
interval
mld-snooping host-aging-time
interval
106
Remarks
N/A
N/A
The default setting is 260 seconds.
The default setting is 260 seconds.
Remarks
N/A
N/A
The default setting is 260 seconds.
The default setting is 260 seconds.