HP 6125G Configuration Manual page 149

[SwitchB] interface GigabitEthernet 1/0/3
[SwitchB-GigabitEthernet1/0/3] undo stp enable
[SwitchB-GigabitEthernet1/0/3] undo lldp enable
[SwitchB-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchB-GigabitEthernet1/0/3] quit
# Create interface Tunnel 2.
[SwitchB] interface tunnel 2
# Configure an IPv4 address for interface Tunnel 2.
[SwitchB-Tunnel2] ip address 10.1.2.2 255.255.255.0
# Configure the tunnel encapsulation mode.
[SwitchB-Tunnel2] tunnel-protocol ipv4-ipv4
# Configure the source address for interface Tunnel 2 (IP address of VLAN-interface 101).
[SwitchB-Tunnel2] source 3.1.1.1
# Configure the destination address for interface Tunnel 2 (IP address of VLAN-interface 101 of
Switch A).
[SwitchB-Tunnel2] destination 2.1.1.1
# Reference service loopback group 1 on the tunnel.
[SwitchB-Tunnel2] service-loopback-group 1
[SwitchB-Tunnel2] quit
# Configure a static route from Switch B through interface Tunnel 2 to Group 1.
[SwitchB] ip route-static 10.1.1.0 255.255.255.0 tunnel 2
Verifying the configuration
Display the status of the tunnel interfaces on Switch A and Switch B:
[SwitchA] display interface tunnel 1
Tunnel1 current state: UP
Line protocol current state: UP
Description: Tunnel1 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID is 1.
Tunnel source 2.1.1.1(Vlan-interface101), destination 3.1.1.1
Tunnel bandwidth 64 (kbps)
Tunnel protocol/transport IP/IP
Last 300 seconds input:
Last 300 seconds output:
4 packets input,
0 input error
12 packets output,
0 output error
[SwitchB] display interface tunnel 2
Tunnel2 current state: UP
Line protocol current state: UP
Description: Tunnel2 Interface
The Maximum Transmit Unit is 1480
Internet Address is 10.1.2.2/24 Primary
0 bytes/sec, 0 packets/sec
2 bytes/sec, 0 packets/sec
256 bytes
768 bytes
141