Need Only A Quick Start; Ip Addressing; To Set Up And Install The Switch In Your Network; Physical Installation - HP ProCurve Switch 6120G/XG Management Manual

Getting Started

Need Only a Quick Start?

The Help Button
Figure 1-5. Button for Onboard Administrator Interface Online Help
1-8

Need Only a Quick Start?

IP Addressing

If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using VLANs, ProCurve recommends that
you use the Switch Setup screen to quickly configure IP addressing. To do so,
do one of the following:
Enter setup at the CLI Manager level prompt.
■
Procurve# setup
In the Main Menu of the Menu interface, select
■
8. Run Setup
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.
To Set Up and Install the Switch in Your
Network

Physical Installation

Use the Installation and Getting Started Guide for the following:
Notes, cautions, and warnings related to installing and using the switch
■
and its related modules