Need Only A Quick Start; To Set Up And Install The Switch In Your Network - HP ProCurve 2600-PWR Series Manual

Access security guide
Hide thumbs Also See for ProCurve 2600-PWR Series:
Table of Contents

Advertisement

If you need further information on Hewlett-Packard switch tech­
nology, visit the HP ProCurve website at:
http://www.hp.com/go/hpprocurve

Need Only a Quick Start?

IP Addressing. If you just want to give the switch an IP address, or if you
are not using VLANs, HP recommends that you use the Switch Setup screen
to quickly configure IP addressing. To do so, do one of the following:
Enter setup at the CLI Manager level prompt.
HPswitch# setup
In the Main Menu of the Menu interface, select
8. Run Setup
For more on using the Switch Setup screen, refer to the Installation and
Getting Started Guide you received with the switch.
To Set Up and Install the Switch in Your
Network
Use the Installation and Getting Started Guide for your switch model
(shipped with the switch) for the following:
Notes, cautions, and warnings related to installing and using the
switch and its related modules
Instructions for physically installing the switch in your network
Quickly assigning an IP address and subnet mask, set a Manager
password, and (optionally) configure other basic features.
Getting Started

Need Only a Quick Start?

1-11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents