Unpacking The Unit - Lennox REFLECTIONS LSE-36R Installation And Operation Instructions Manual

13. Do not insert or allow foreign objects to
enter any ventilation or exhaust opening, as
this may cause an electric shock, fire, or
damage to the appliance.
14. To prevent a possible fire, do not block air
intakes or exhausts in any way. Do not use near
soft surfaces, like a pillow, where openings
may become blocked.
15. This appliance has hot and arcing or spark-
ing parts inside. Do not use it in areas where
gasoline, paint or flammable liquids are used or
stored. This fireplace should not be used as a
drying rack for clothing, nor should Christmas
stockings or other decorations be hung near it.
16. Use this appliance only as described in this
manual. Any other use is not recommended by
the manufacturer and may cause a fire, electric
shock or injury to persons.
17. Avoid the use of an extension cord be-
cause the extension cord may overheat and
cause a risk of fire. However, if you have to
use an extension cord, the cord shall be No.
16 AWG minimum size and rated not less
than 2025 Watts. The extension cord must
be a three wire cord with grounding type plug
and cord connection.
SAVE THESE INSTRUCTIONS.
18.
LOCATING YOUR REFLECTIONS
ELECTRIC FIREPLACE
Your new fireplace may be installed into exist-
ing framing. It may also be built into a wall,
see Figure 3 , or set in a freestanding mantle
available from your dealer ( see Figure 12 ).
When choosing a location for your new fire-
place, ensure that the general instructions are
followed. Also, for the best effect, install the
fireplace out of direct sunlight and away from
overhead lighting.
Figure 1

UNPACKING THE UNIT

Refer to Figure 2 for identification of the
components as the product is unpacked.
Be sure to identify all components before
proceeding with the installation.
1. Cut the top band of the package assembly
and lift the container top off. This top can be
used as a clean surface to assemble the televi-
sion assembly.
2. Remove the grate (1) and ember bed (2) and
dust cover (11), set them aside in a safe place
off of the floor.
3. Discard the corrugated support (3) and lift
out the log package (4). Set it with the grate
and ember bed. Remove the door rail and
grille cover (12) and set it aside.
4. A panel of glass (5) is located in the front of
the carton wrapper. Lift the glass panel out
and set it with the logs. All of these items will
be installed in the final phase.
TYPICAL PACKAGING
TM
8
7
Figure 2
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
2
11
4
3
12
13
5
5. Cut the bottom band and remove the car-
ton wrapper (6). The wrapper can be used as
a working surface in front of the installation
opening.
6. Remove the Television support tray (7)
from the unit. Place it on the carton top for
assembly shortly.
7. Remove the television box (8) from inside
the unit and set it near the support tray. Re-
move the side refractory panels (13).
8. Remove and discard the protector pad (9).
9. Lift the unit (10) off of the carton bottom
and set it in front of the framed opening on the
carton wrapper. Discard the bottom cap.
All of the components numbered should be
identified before proceeding. Order informa-
tion for any missing components can be found
in the replacement parts list on page 12.
Carton Top
1
10
9
6
3