Clear Area Command; Print Direction: Printing Bottom First; Print Direction: Printing Top First - Toshiba B-SX4T Series Specification

6.3.6

CLEAR AREA COMMAND

Function Clears the designated area or reverses the white/black dot pattern in the designated
area in the drawing area.
Format [ESC] XR; aaaa, bbbb, cccc, dddd, e [LF] [NUL]
Term aaaa:
bbbb:
cccc:
dddd:
e:
Explanation
Origin of
coordinates
(0, 0)
Start point
Effective
print length
X
0
Y

[Print direction: Printing bottom first]

Notes (1)
(2)
(3)
Designated area start point X-coordinate
Fixed as 4 digits (in 0.1 mm units)
Designated area start point Y-coordinate
4 or 5 digits (in 0.1 mm units)
Designated area end point X-coordinate
Fixed as 4 digits (in 0.1 mm units)
Designated area end point Y-coordinate
4 or 5 digits (in 0.1 mm units)
Type of clear
A: Clears the contents in the designated area to zeros.
B: Reverses the white/black dot pattern in the designated area.
Backing paper
Label
End point
Effective
print width
Paper feed direction
The result is the same even if the start and end point coordinates are reversed.
The result is the same even if the start and end point coordinates are set to an
upper right and a lower left points, respectively.
The start and end point coordinates of the designated area must be set within the
effective print area set by the Label Size Set Command ([ESC] D).
Effective
print length
Y
0
X

[Print direction: Printing top first]

- 54 -
[ESC] XR
End point
Start point
Origin of
coordinates
Effective
print width
Paper feed direction
Backing paper
Label
(0, 0)