Chapter 3 - SpaceLink Access Point Manager
If you have a DHCP (Dynamic Host Configuration Protocol) server on the
network, then the DHCP server will automatically assign the SpaceLink Access
Point an IP address when the SpaceLink Access Point is powered up. To determine
what IP address has been assigned to the SpaceLink Access Point, review the IP
address on the "General" page after clicking "Refresh AP Status".
Specify an IP Address
The SpaceLink Access Point also accepts a static IP address. You may
manually configure the IP address and subnet mask on the "IP Config"
page. Enter an IP address and a subnet mask in the field provided to assign
the SpaceLink Access Point a static IP address. Normally you do not need
to enter a "Gateway" address unless you want to manage the SpaceLink
Access Point in another IP domain. Enter "0.0.0.0" for the Gateway if the
Access Point is in your IP domain.
Only allow IP Packets
If you check this item, only IP protocol packets will be allowed to pass
through the SpaceLink Access Point and other protocol packets will be
filtered out
Buttons
These buttons will be available if you make changes to this page.
Undo: If you make a mistake while configuring this page, click "Undo" to
revert the parameters on this page to the last saved settings
Apply: Clicking "Apply" will attempt to save the currently modified
settings. You will be asked for the password to save changes.
SpaceLink Access Point
29