Table of Contents
Advertisement
Chapter 3 - SpaceLink Access Point Manager
Buttons
Search AP: Searches for compatible SpaceLink Access Points that are
within your subnet. This function cannot search across gateways. If you
cannot see your SpaceLink Access Point, use the "Reset to Defaults" on
the back of the SpaceLink Access Point and try again. See Appendix for
more information on connection problems.
Connect to AP: The SpaceLink Access Point Manager can connect to any
compatible user-entered SpaceLink Access Point using its IP address even
across gateways.
Refresh AP status: The SpaceLink Access Point Manager will refresh all
information from the SpaceLink Access Point and update all the pages in
the SpaceLink Access Point Manager utility.
Reboot AP: This has the same effect as turning OFF and ON the SpaceLink
Access Point. If the SpaceLink Access Point is not working correctly,
"Reboot AP" may solve the problem.
Reset to Defaults: Resets the SpaceLink Access Point to its factory default
settings.
Change Password: Change the
password required to make setting
changes. You can enter any usable
characters between 1-16 characters long
(cannot be left blank). Each time you
apply a change, you will be prompted
to enter a Password. The default
Password is "asus" (lower case). If you
forget the SpaceLink Access Point's
password, you can reset the SpaceLink Access Point to its factory settings
(see troubleshooting).
Note: The password is case sensitive.
Left Pane Tree View
st
1
level: SSID
nd
2
level: SpaceLink Access Point names
rd
3
level: Associated wireless mobile clients
Note: SpaceLink Access Points with the same SSID will gather in
the same branch.
26
SpaceLink Access Point
Advertisement
Table of Contents
