Stand mounting
1.
Place the camera in a desired position
on the surface.
2.
Adjust the camera's shooting angle as appropriate.
n
Do not put excessive force.
`
Otherwise, it may cause damage
to the camera.
If you use the camera in contact
`
with the base unit, this may
cause noise on the video. It is
advisable to use the camera in a
5º to 10º tilt.
3.
Connect the power
cable.
n
When done, remove the protective film from the lens.
`
Wall mounting
1.
Use a double-sided tape to secure the bracket to
a desired position.
n
You can use the screws to tighten the camera. (not
`
included)
The double-sided tape cannot be reused after being
`
used once.
Keep the installation surface clean before attaching
`
the double-sided tape to the bracket.
Otherwise, the adhesive force may be deteriorated,
causing a fall of the camera.
2.
Fit the protruding points (x2) of the bracket into the corresponding holes
of the camera before turning clockwise to fix the camera.
02