Initial Settings; Adjusting Initial Settings; Setting The Time; Setting The Fm Tuning Step - Pioneer KEH-P7025 Operation Manual

Section

Initial Settings

07

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1
display
FUNCTION
Shows the function status.
1 Press
SOURCE
off.
2 Press
FUNCTION
appears in the display.
3 Press
FUNCTION
settings.
Press
FUNCTION
the following settings:
— —
CLOCK FM AM
— —
BRIGHT SW
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press
• You can also cancel initial settings by holding
down
FUNCTION

Setting the time

This is used to set the time on the unit's clock
display.
1 Press
FUNCTION
Press
FUNCTION
display.
30
En
1
and hold until the unit turns
and hold until time
to select one of the initial
repeatedly to switch between
— — —
WARN AUX DIM
TEL
BAND/ESC
until the unit turns off.
to select the
CLOCK
until the time appears in the
2 Select the portion of the time display you
wish to set with 2/3.
Pressing 2/3 will select a portion of the clock
display:
—
HOUR MINUTE
As you select portions of the clock display the
portion selected will blink.
3 Select the correct time with 5/∞.
Pressing 5 will increase the selected hour or
minute. Pressing ∞ will decrease the selected
hour or minute.

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
—
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
.
2 Select the FM tuning step with 2/3.
Pressing 2/3 will switch the FM tuning step
between 100 kHz and 50 kHz. The selected FM
tuning step will appear in the display.
Note
• If seek tuning is performed in 50 kHz steps,
stations may be tuned in imprecisely. Tune in
the stations with manual tuning or use seek
. tuning again.
to select .
FM
repeatedly until
FM Step