Table of Contents
Advertisement
2.3
Materials Specifications
Liquid End
Wetted Castings:
Pump Shell and Shaft:
Stages:
O-Ring Seals and Shaft Bearings:
Motor Module
Power Requirements
Motor Adapter and Inlet Flow Tube:
O-Ring Seals:
Motors:
Wire Insulation:
Antifreeze:
WARNING:
Special Liquids:
Tonkaflo pumps can handle a variety of liquids. For liquids other than water; aque-
ous solutions or corrosive solutes, consult your local Tonkaflo distributor or factory.
Special Materials of Construction:
Ethylene propylene dimonomer (EPDM) and Teflon* pump shaft bears are available
for some models. Contact your distributor or the factory.
*Teflon is a trademark of E.I. DuPont de Nemours and Company, Inc.
90°F (32°C) MAXIMUM OPERATING TEMPERATURE
4
316 Stainless Steel
316 Stainless Steel
Noryl*
Buna-N Rubber
1-Phase
208, 230 V (60 Hz Operation)
220, 230, 240V (50 Hz Operation)
3-Phase
208, 230, 460, 575V (60 Hz Operation)
220, 380, 400, 415V (50 Hz Operation)
316 Stainless Steel
Buna-N Rubber
Stainless steel shaft and stator shell,epoxy-
encapsulated stator, electroless nickle-plated
cast iron or Noryl plastic-covered carbon
steel stator ends, bronze filter check valve,
nitrile and neoprene rubber seals
Neoprene, chloroprene, hypalon, and/or poly-
olefin epoxy-potted
20% Propylene glycol (non-toxic)
80% Water
Advertisement
Table of Contents
