HP 348773-001 User Manual page 70

Problem
I cannot hear the guidance
instructions
My map is stuck in map pan-
ning mode
I cannot load an additional map
There is not enough memory to
install my map
How do I know my GPS
receiver is working
I cannot find the POI I am look-
ing for on the map
I cannot switch on my device
The application has frozen my
device
The display mode on my device
is incorrect for the time of day.
User's Guide
Check the volume is not muted. From the map view click the
Speaker icon in the menu bar at the bottom of the map.
From Tools select Guidance Volume. Increase the volume, as
required.
To exit Map Panning Mode tap on the red circle with a white x at
the bottom right hand side of the screen.
Before installing additional maps, verify Navigation System is not
running. From the Start menu, tap Settings >System > Memory.
From the Running Programs, tap iPAQ Nav System > Stop.
Verify there is sufficient memory available on your PocketPC or
selected storage card.
Remove programs from your PocketPC main memory to make
space available
Select a smaller map to install. Install maps by City rather than by
Region (state).
Install an additional SD or CF card in the expansion slot.
Verify the GPS receiver has a flashing blue light.(Bluetooth radio
is switched on.)
Verify the GPS receiver has a green light. A solid light indicates
there is no valid GPS signal; a flashing light indicates there is a
valid GPS signal.
From the Navigation System Main Menu select GPS info. The
number of satellites delivering a signal to the GPS receiver dis-
plays.
Verify the POI icons are enabled. From the Tools menu select Dis-
play options. Turn on POI icons by tapping the appropriate box.
POI icons only display when the map is zoomed in to the four
closest zoom levels (1,000 ft or closer).
Some POIs are hidden on the map by other POI icons.
To display POIs, tap the Main button > Destinations > Points of
Interest. Tap on the POI > Map to center the map on the POI.
Verify the PocketPC is charged. Connect the PocketPC to a
charger.
A soft reset is often necessary for the device to switch on. (Refer to
your iPAQ PocketPC User's Guide for details. All data and settings
are retained).
Perform a soft reset. See your iPAQ PocketPC User's Guide for
instructions. (All data and settings are retained.)
From the Tools menu select Display Options. Switch Color to the
appropriate display mode (Day or Night mode).
If the mode is set to Auto, verify the PocketPC clock is set cor-
rectly.
Solution
Troubleshooting
6-2